Product description for 310ml Eco-friendly Primerless High strength adhesive for Bus glass

1.PL870 is a one component moisture curable polyurethane glass adhesive.

2. It is  good sealing performance and cohesion.

3. It has no corrosion, pollution and environmental pollution to the bonded substrate,

    and has good adhesion to metal, glass and other substrates.

4. it is used for the windshield and side
 

Product application for 310ml Eco-friendly Primerless High strength adhesive for Bus glass

1.Maintenance and repair of automotive windshields and side window glass through bonding and sealing techniques.

2.Designed for achieving high-strength adhesion between glass and the body of various vehicles.

3.Specifically formulated for the installation and sealing of glass in low-speed electric vehicles.

4.Exhibits excellent adhesion to various substrates, including glass and aluminum plates.

5.Suitable for use in buses, cars, railway vehicles (metros, high-speed trains), ships, spacecraft, engineering machinery vehicles, carriages, and  other types of vehicles. Widely utilized in high-end car dealerships and for special vehicles.

Product features for 310ml Eco-friendly Primerless High strength adhesive for Bus glass

1. Environmentally friendly with no harmful emissions after curing, ensuring safety for humans.
2.Excellent adhesion and sealing properties with high bond strength. No primer required.
3.Easy to apply due to good thixotropic and extrusion properties, allowing for convenient construction.
4.Can withstand high dynamic loads without sagging during application interruptions.
5 Single-component formula that cures with moisture, suitable for vertical application without dripping.
6. Offers good resistance to aging and weather conditions.

Technical data table for 310ml Eco-friendly Primerless High strength adhesive for Bus glass

Attention:

Fast and keep away from children; Avoid contact with eyes and skin before curing. In case of accidental contact with skin, first scrub with soapy water or alcohol, and then rinse with clean water. In case of contact with eyes, rinse with plenty of water first, and seek medical advice immediately if necessary.

Directions for Use  for 310ml Eco-friendly Moisture-curing PU urethane adhesive Sealant

Tool: Pneumatic plunger caulking gun

Cleaning: Clean and dry all surfaces by removing foreign matter and contaminants such as oil dust, grease, frost, water, dirt,

old sealants and any protective coating.

Steps:

1. Cut nozzle to give the required angle and bead size

2. Pierce the membrane at the top of the cartridge and screw on the nozzle

3. Place the cartridge in an applicator gun and squeeze the trigger with equal strength

Packing:

Substrate pretreatment for for 310ml Eco-friendly Moisture-curing PU urethane adhesive Sealant

The surface of the bonded substrate must be clean and dry without dust, oil and water stains. The bonded
substrate should be cleaned and pretreated with detergent or primer. If it is not, it may cause bonding failure. The glue shall be applied and cured according to the construction method, and the safe driving time is related to the ambient temperature and humidity.

Construction
Ambient temperature and humidity have a great impact on the surface drying and curing of glass adhesive. It
is recommended that the construction ambient temperature be 5 ~ 35 ℃, and the humidity be 50 ~ 70% RH. When the temperature is lower than 5 ℃, it is recommended to put the product in an environment of
30-40 ℃ for heating for 1H before use (the heating time cannot exceed 3H)
The construction method can refer to the construction instructions or consult our technicians.

Storage:
Sealed and stored in a low temperature and dry place. It is recommended to store in an environment with a
temperature of 5~25 ℃ and a humidity of ≤ 50% RH.
Storage period: 9 months

Transportation: moisture proof, rain proof, sun proof, high temperature proof, keep away from heat source, handle with care, and do not squeeze or collide.